Before You Start; Connecting The Motomaster® Eliminator® Mobile Power Outlet; Connecting The Connector Cables To The Power Inverter - Motomaster Eliminator Product Manual

13

Before you start

• Unpack the power inverter. Inspect the unit for damage. If the unit has been damaged, contact
the retailer immediately.
The carton should contain:
• Power inverter
• DC cable with cigarette lighter plug (J)
• DC cable for direct connection to 12 V battery (I)
• Owner's manual
•
• Positioning of the power inverter:
DRY
Do not expose to water, rain, moisture, snow or spray.
40 °C (32 °F and 104 °F). Keep it away from heating vents and direct
COOL
sunlight. We recommend using the inverter in environments not
exceeding 25 °C (77 °F).
For proper cooling, allow at least 2" (5 cm) of clearance around the
WELL-VENTILATED
inverter.
Choose a location that is free of any debris that could get into the
CLEAN
inverter.
Do not install the inverter in a compartment with batteries or
SAFE
011-1870-6-Mobile-Power-Outlet_300W-EN-07.indd 13-14
Connecting the MotoMaster® Eliminator® Mobile Power Outlet
CAUTION!
Prior to connecting to the power source:
Make sure that the total wattage of the devices you are planning to connect to the power
inverter does not exceed the maximum load of the respective power outlet.
CONNECTION WITH
LOAD CONNECTED (W)
CIGARETTE LIGHTER PLUG
Continuous load under 100 W Yes
Continuous load between
No
100 and 240 W

Connecting the connector cables to the power inverter

• M
the "0" position.
• Choose the DC cable (I / J) suitable for connecting the AC products that you want to operate.
CAUTION!
Only use the cables provided with your power inverter.
• DC cabling terminals (B / C).
14
CONNECTION WITH
VEHICLE
Yes
Yes
< 100 W
< 240 W
12/13/12 7:22 PM