Switching On/Off; Using The Usb Port - Motomaster Eliminator Product Manual

19
If you are going to disconnect the battery, switch the inverter off first ( Switching on/off).
Always disconnect the power cables from the vehicle battery when you are not using the device.

Switching on/off

• Be sure to have your power inverter properly placed and connected according to the wattage that
is to be connected before attempting to switch it on.
• Switch the battery on in case it is switched off.
• Set the on/off switch (H) to the "I" position to switch on the inverter.
The green inidcator (F) lights up, indicating that the inverter is operating normally and that the
AC outlet and the USB port are powered.
• Plug in the devices that you want to operate to either the AC outlet or the USB port.
After plugging in the devices, turn them on ONE AT A TIME. This will ensure that the inverter
does not have to deliver the surge currents required for all the loads at once.
• Set the on/off switch (H) to the "0" position to switch off the inverter.
011-1870-6-Mobile-Power-Outlet_300W-EN-07.indd 19-20
CAUTION!
CAUTION!
CAUTION!
CAUTION!
Switch the inverter off and disconnect it from the power source when it is not in use.
IMPORTANT!
When the inverter is switched off, it draws no current from the battery. When the inverter is
switched on without any load connected to it, the inverter draws approx. 0.3 A from the battery.
This low current draw will eventually discharge the battery.

Using the USB port

Plug the USB-powered device into the inverter's USB port (d) and operate normally.
IMPORTANT!
This unit's USB charging port does not support data communication. It only provides (5 V/2.1 A)
dC power to an external USB-powered device. Not all mobile phones are provided with a
charging cable. data cables are not supported by this device. Please check with your mobile
phone dealer for the correct charging cable.
20
12/13/12 7:22 PM