Software Components; Engineering Software; Firmware - Siemens SINAMICS S120 Manual

SINAMICS S120 Fail-Safe Drives
Components
Signal cable
DMM to Motor2:
Power cable
DMM to motor1:
Power cable
DMM to motor2:
The function example was tested with the hardware components listed
Note
here. Other components that have the same function can be alternatively
used. If other components are used it may be necessary to use a
different parameterization and also change the component wiring.
3.2

Software components

3.2.1

Engineering software

Table 3-2
Components
STEP 7
S7 Distributed Safety
Programming
STARTER
or, as an alternative to the STARTER software:
SIMOTION SCOUT
3.2.2

Firmware

All of the SINAMICS components must have firmware release V2.5 SP1 or
higher.
I DT Safety Integrated
Type
Pre-fabricated signal cable
(SINAMICS DRIVE-CLiQ) connector
IP20/IP67, with 24 V MOTION-
CONNECT 500 length (M) = 2
Pre-fabricated power cable
(1FT/1FK/1PH to SINAMICS) 4x1.5
2
C, connector size 1/1.5 mm
UL/CSA DESINA, MOTION-
CONNECT 500 Dmax=11.5 mm,
length (m) = 2
Pre-fabricated power cable
(1FT/1FK/1PH to SINAMICS) 4x1.5
2
C, connector size1/1.5 mm UL/CSA
DESINA, MOTION-CONNECT 500
Dmax=11.5 mm, length (m) = 2
Type Order No./Ordering data
V5.4 SP2 6ES7810-4CC08-0YA5
V5.4 SP3 6ES7833-1FC02-0YA5
V4.1 SP1 6SL3072-0AA00-0AG0
V4.1 SP1 6AU1810-1BA41-1XA0
Page 10/43
Entry ID: 28424136
Order No./Ordering data
6FX5002-2DC10-2AA0
6FX5002-5CS01-1AC0
6FX5002-5CS01-1AC0
Qty.
1
1
1
1
MC-FE-I-005-V11-EN
Qty. Manufact.
1 Siemens
1 Siemens
1 Siemens
Manufact.
Siemens
Siemens
Siemens
Siemens