8. Loosen the inner set
screw, and spin the
handwheel until the
needle is top dead
center.
Rotate the sleeve until
the magnet is directly
over the index sensor,
then tighten the set
screw. The magnet
should set about 1/4"
above the sensor.
There is a red light on
the control box board.
As the index passes
over the sensor the
light will illuminate.
The needle should be
top dead center when
the light goes from on
to off.
9. Power off the control
box.
Page 30
Set screw
Related Products for Quilt EZ Perfect Stitch