Advertisement
the frame.
6. Use the #29 drill to
drill a pilot hole in the
larger drill point
Then drill the point
with a 3/4" bit.
Rear Display
1. Tape the rear display
template to the back
base of the machine.
2. Use a hammer and
punch to mark the drill
points.
3. Use the power drill and
a #29 bit to drill the
two smaller points.
4. Use a #8-32 tap on the
drilled holes.
5. Use a #7 bit to drill
four larger points.
6. Tap drilled holes with a
#1/4-20 tap
Page 14
Advertisement
