Re-Ignitor; Flue Baffle; Burner Jet; Gas Components - Electrolux ICON E24WC160ES Technical & Service Manual

Sealed System

Re-ignitor:

An electric re-ignitor powered by a supply voltage of approximately 12V, generates via an ignition cable and an
electrode, a spark in the burner where the gas is lit.
The re-ignitor automatically repeats this operation until a "feedback" signal to the electronics registers the presence
of a flame. On the re-ignitor, there is a voltage supply connection which is powered by the re-ignitor switch. There is
also a connection for the switch control light.

Flue Baffle:

This distributes the heat in the boiler area during the gas operation (not required for all models). A performance loss
occurs if this baffle is missing. The length of baffle will vary depending on model.

Burner Jet:

Burner jets are designed for the specific gas operating pressure (28 to 50 mbar). Only the burner jets specified for the
model and gas pressure stated on the data plate, must be used.

Gas Components

Flue Baffle
Electrode
Burner

Electrical Components

Gas Supply Pipe
Burner Jet
Aeration Hole
Heating Elements
Thermocouple
Electric Thermostat
230 Volt Only
230 Volt Switch
12V/24V Switch
4-4
Gas Control Valve
Gas Filter
Gas Connection
Gas Thermostat
Ignition Device
Switch
Ignition Cable
Piezo Igniter
Cover
Reigniter
Ignition Cable Complete
With Electrode