Advertisement
Step 5. Connect Entry Plate to Battery Cells
Place the battery entry plate in front of the battery box assembly with the positive (Red) wire
facing left, and negative (Black) facing right.
Install positive (Red) wire extending from the battery pack entry plate to positive terminal of
battery #3. Ensure positive (Red) wire extending from battery pack entry plate, and (Red)
wire labeled #3 from BMS, are placed onto terminal bolt and secured to positive terminal
of battery #3.
Repeat similar steps to install negative (Black) wire extending from battery pack entry plate, and
(Black) #4 black wire extending from BMS, to negative terminal of battery #4.
QUICK START GUIDE
Step 6. Properly Tighten Battery
Twist the base
Terminal Hardware
of the Fat
Wrench until
Unpackage provided torque screwdriver and
the black line in
set to 30-inch pounds.
the white
indicator
reaches
*NOTE:
manufacturer's specifications may cause
30 in. – Lb.
adverse battery performance.
SUBMERSIBLE BATTERY INSTALLATION
Failure to torque battery hardware to
5
Advertisement
