Advertisement
•
Connect negative (-) lead of charger output cable to negative (-) terminal post of
submersible battery pack. ADVISORY: Charger clamps MUST connect to brass
terminal post only. Conducting charging cycle with charger clamps connected to
stainless steel seal nut will void product warranty.
•
Place selector switch of charger to "ON" position. LED indicator will display charge
status and illuminate "Green" when charging cycle is complete.
Once charged, replace protective pipe plugs over positive (+) and negative (-) terminal posts.
Tighten plugs to just beyond hand tight. Excessive tightening or additional thread sealant is not
necessary to maintain waterproof integrity of battery box enclosure.
Submersible Battery Pack is ready for use with Submersible Antenna System.
QUICK START GUIDE
705 S 8
ST, BOISE, ID USA
TH
|
+1 208.275.0011 |
SUBMERSIBLE BATTERY INSTALLATION
customerservice@biomark.com
11
| www.biomark.com
Advertisement
