Advertisement
Installing a Flame Ionization Detector on an Agilent 6850 Gas Chromatograph
The FID detector assembly is a factory-assembled, tested, and calibrated
unit. Disassembly of the unit is not required for installation.
Nutwarmer
Insulation
(3 pieces)
Screws
FID signal board
Tools Required
Torx™ T-20 driver
Flat blade screwdriver
Open end wrenches
Safety Information
Before continuing, read the safety information on your Agilent 6850 Gas
Chromatograph User Information CD-ROM.
2
Ribbon cable
Heater/sensor cable
FID assembly
Ignitor cable
Flow module cable
Flow module
Advertisement
