Command Line Interface - Dataprobe iBootBar Installation And Operations

iBootBar

Command Line Interface

All configuration parameters are set using the Command Line Interface (CLI). The CLI is accessed through the network,
using a telnet client, or through the serial port, or data modem using a terminal client.
Open a telnet client and point it to the current IP Address. (Factory Default is 192.168.0.254)
Connect to the Serial port or via dial modem (-M versions) (Factory Default is 115200,8,n,1)
Upon connection, press Enter, then enter the username and password when prompted
(Factory Default for both is admin)
A complete list of commands and syntax is found on page 12 through 16.
Setting the IP Address
iBootBar comes with factory installed IP address 192.168.0.254
There are three techniques to setting the IP address of the iBootBar.
1. Terminal Client software via Telnet, Serial, Modem.
2. Automatically from a DHCP Server
3. ARP / Ping
To configure the mode to set the IP address, access the iBootBar command line interface (CLI) and use the set ipmode
command as indicated below.
Setting the IP address using CLI
The following commands are used to set the IP parameters
set ipaddress <dotted decimal>
set subnet <dotted decimal>
set gateway <dotted decimal>
If you wish to prevent DHCP or ARP-Ping from altering the IP Address, also enter the following command
set ipmode static
Changing any of these values will require a reboot of the unit. Type the command "reboot" as indicated, press the reset
pushbutton on the front panel, or remove and restore all power to the iBootBar.
Setting the IP address from a DHCP Server
A DHCP server will automatically assign an IP address (dynamic address) as well as Subnet Mask and Gateway to the
iBoot.
To enable this feature, configure the iBootBar with the command
Then power cycle the iBootBar, or enter the command
To find the address of the iBootBar you will need to query your DHCP server and locate the MAC address of the iBootBar
in the DHCP server's IP / MAC table. You can also access the CLI and use the
Setting the IP address using ARP / Ping
The ARP / Ping technique uses a PC running a command line (DOS Window) to set the IP Address. To set the IP address
using ARP, connect the iBootBar to your local network and apply power. The IP address to be assigned to iBootBar must
be use the same network segment as the computer assigning the address. ARP does not work across routed or switched
networks.
ibootbar_v1.2x
ex. 192.168.0.125
ex. 255.255.255.0
ex. 192.168.0.2
reboot
set ipmode dhcp
command.
get network
Page 8