Startup / Operation - BOMANN VS 2262 Instruction Manual

Reverse the Door Opening Reverse the Door Opening
Reverse the Door Opening Reverse the Door Opening
If required, the door opening can be moved from the right (supplied condition) to the left side.
WARNING: WARNING:
WARNING: WARNING:
When replacing the door stop, the appliance must be disconnected from the power supply. Always unplug the
appliance first.
NOTE: : : : NOTE NOTE NOTE
• When installing, ask another person to assist.
You possibly need:
•
Open the appliance door a little and take it carefully of the lower door hinge.
• Loosen the screw of the door stopper and move it to the other door underside. Place the door on a padded
surface to prevent it from scratches.
• Tilt the appliance slightly backwards and block it in this position. Unscrew the feet. Dismount the lower
door hinge by loosening the screws.
• Install the lower door hinge according to the opposite appliance side, after you have unscrewed the hinge
pin and used by the other hinge side. Turn in the feet accordingly.
• Replace the appliance upright again. Insert the appliance door on the lower hinge pin and fix the door to
the property position.
• Transfer the upper door hinge according to the opposite appliance side. Put the hinge pin in the hole of the
appliance door and tight the hinge.
• Replace the appliance top cover. Tight the screws and put the caps on.
• Check if the door is arranged vertical as well as horizontal, so that a smooth opening and closing of the
door is ensured.
Prior to first use Prior to first use Prior to first use Prior to first use
CAUTION: : : : CAUTION
CAUTION CAUTION
After transport, the appliance should be left standing upright for about 4 hours before connecting to the power
supply. Nonobservance could lead to malfunction of the cooling system and causes an appliance breakdown.
Clean the interior of the appliance including all accessory parts located inside. Consider the instructions which
we provide in the chapter "Cleaning and Maintenance".
screw wrench, Phillips screwdriver as well as a thin-blade screwdriver.

Startup / Operation

Startup / Operation Startup / Operation Startup / Operation
19
• Remove the caps at the appli-
ance top cover. Unscrew the
screws underneath and the
screws at the back of the top
cover. Remove the top cover.
• Dismount the upper door hinge
by loosening the screws.