Canon iR 3300 Series Reference Manual page 27

2 2 2 2
Make sure that the breaker lever automatically goes to the OFF position Make sure that the breaker lever automatically goes to the OFF position
Make sure that the breaker lever automatically goes to the OFF position Make sure that the breaker lever automatically goes to the OFF position
(" (" (" (" " side), and confirm that the power is cut OFF. " side), and confirm that the power is cut OFF. " side), and confirm that the power is cut OFF. " side), and confirm that the power is cut OFF.
IMPORTANT
• • • •
Do not use the test button to turn the power ON and OFF.
• • • •
If the breaker lever does not go to the OFF position ("
• • • •
If the breaker lever does not go to the OFF position ("
three times, contact your service representative.
• • • •
The breaker lever may stop between ON and OFF, depending on the type of breaker.
• • • •
When the breaker lever is stopped between ON and OFF, it is in an OFF state.
3 3 3 3
Once the step above is completed and confirmed, turn the main power Once the step above is completed and confirmed, turn the main power
Once the step above is completed and confirmed, turn the main power Once the step above is completed and confirmed, turn the main power
switch OFF ( switch OFF (
switch OFF ( switch OFF (
ON
("I I I I " side)
OFF
(" " side)
ON
("I I I I " side)
OFF
(" " side)
side). side).
side). side).
ON
OFF
("I I I I " side)
(" " side)
" side) repeat step 1.
" side) despite carrying out the above procedure two or
Periodic Inspection of the Breaker xxv xxv
xxv xxv