Motorola M68705EVM User Manual page 51

MD
Memory Display
3.6. 7 Memory Display
MD <address1 > [<address2>]
where:
<address1 >
<address2>
Beginning address of the memory to be displayed.
Ending address of the memory to be displayed.
MD
The MD command is used to display a section of user memory beginning at address1 and
3
continuing to address2. If address2 is not entered, 16 bytes are displayed beginning at
address1. If address1 is greater than address2, the monitor prompt is displayed.
>MP 80 AO
NOTE
The EVM does not support any type of data flow control on the
terminal 1/0 port. If the external terminal connected to the EVM
cannot support 9600 baud, the terminal CRT display may become
garbled after one full display of data.
EXAMPLES
0080 AA AA AA AA AA AA AA AA AA AA AA AA AA AA AA AA
0090
AA AA AA AA AA AA AA AA AA AA AA AA AA AA AA AA
OOAO AA AA AA AA AA AA AA AA AA AA AA AA AA AA AA AA
>
>MP 122
0122 AA AA AA AA AA AA AA AA AA AA AA AA AA AA AA AA
>
EVALUATION MODULE USER'S MANUAL
M68705EVM
MOTOROLA
3-17