Table of Contents
Advertisement
G
Go
G
3.6.5
Go
G [<address>]
where <address> is the starting address where program execution begins.
The G command allows the user to initiate user program execution (free run in real time).
The user may optionally specify a starting address where execution is to begin. Execution
starts at the current Program Counter (PC) address location, unless a starting address is
specified.
Program execution continues until a breakpoint is encountered, or the EVM
ABORT switch S2 is activated (pressed), or the MASTER RESET switch SS is pressed.
EXAMPLES
>G
>G 100
>.G....Jill
Abort
S=7F
P=0104
A=55
EVALUATION MODULE USER'S MANUAL
M68705EVM
X=FF
DESCRIPTION
Go to user map and begin program execution
at current PC address location.
Go to user map and begin program execution
at PC address location $100.
Transfer of EVMbug monitor control.
C=E8
111.
I . ..
ABORT switch S2 is used to restore
EVMbug
monitor control
if
no
breakpoints
were
preset prior to the G command entry.
MOTOROLA
3-15
Advertisement
Table of Contents
