MULTIQUIP Whiteman Series Operation Manual page 26

PRECLEANER SERVICE
If so equipped, wash and re-oil the precleaner every 25
hours of operation (more often under extremely dusty or
dirty conditions).
To service the precleaner perform the following steps and
refer to Figure 13:
1. Release the latches located on either side of the air
cleaner cover (Figure 13), and remove the cover.
2. Remove the foam precleaner from the paper air cleaner
element.
3. Wash the precleaner in warm water with detergent.
Rinse the precleaner thoroughly until all traces of
detergent are eliminated. Squeeze out excess water
(do not wring). Allow the precleaner to air dry.
4. Saturate the precleaner with new engine oil. Squeeze
out all excess oil.
5. Reinstall the precleaner over the paper air cleaner
element.
6. Reinstall the air cleaner cover and secure the latches.
PAGE 26 — HTN27-28 RIDE-ON TROWEL • OPERATION MANUAL — REV. #2 (04/21/14)
MAINTENANCE
AIR CLEANER
COVER
LATCH
SPRING
LEVER
LATCH
LEVER
LATCH
PIN
INNER
AIR CLEANER
COVER
PRE-CLEANER
ELEMENT
AIR CLEANER
ELEMENT
SEAL
AIR CLEANER
BRACKET
AIR CLEANER
BASE
AIR CLEANER
BASE GASKET
INTAKE
MANIFOLD
GASKET
Figure 13. Air Cleaner Components
WING
NUT
SCREW
INTAKE
MANIFOLD