Table of Contents
Advertisement
5.4. MANUAL
The MANUAL function is divided into three
different options:
1.- Cleaning: On pressing 1 and ENTER, the
cleaning sequence will be activated or it will be ended
if it was already working.
2.- Outlets: On pressing 2 and ENTER another
screen will be displayed. This screen will allow you to
activate any outlet with a maximum of 6 at the same
time. You will not be able to leave this function while
any outlet is activated. Enter number 99 to activate the
general outlet.
3.- Stop: On pressing 3 and ENTER the unit will
be
stopped,
appearing
CONSULTATION) a "SYSTEM AT STOP" message.
But you will also be able to access all the functions. In
order to end the stop proceed in the same way as you
did to activate it.
MANUAL: Cleaning=1
Outlets=2 Stop=3
Manual / Outlets
Number of outlet=00
03 12 00 00 00 00
5.5. TOTALS
The TOTAL function gives, in the first screen, the
total or general value of the time and volume of the
water that has been circulating through the filters.
On pressing ENTER or the arrow, the second
screen is displayed. This screen shows the cleanings,
which have taken place in units (min/m3) and the
ones, which have taken place by order of the
differential pressure gauge.
The third screen asks whether these data are to
be erased.
(by time)
(by volume)
on
the
screen
Time general
total = 0000:00
Volume general
total = 000000 m3
Start total :
unit.=0000 pre.=0000
Erase totals ?
(Yes/No) : No
5.6. CONSULTATION
On pressing the "CON" key the following screen
will be displayed.
The first screen shows the number of the filter,
which is being cleaned, and whether it is at pause
between filters.
On the right margins we can see whether the
inputs of Start Cleaning (SC) and Breakdown (BR)
starts by pressure gauge are activated. Flow is
another information. When it is by time it indicates with
a Yes/No whether there is water circulation and when
it is by volume it shows the instantaneous flow in
cubic metres per hour.
The second screen, working with time, shows us
how long water has circulated since the last cleaning;
and by volume, the circulated cubic metres.
(at
When the unit is stopped because of a
breakdown or a manual stop, two screens will be
displayed showing it.
Another screen is shown when the battery
tension is not enough to activate the valves.
Filter = 01 pause SC
Flow = Yes
(by volume)
(by time)
(by volume)
* SYSTEM AT STOP *
** BREAKDOWN **
** LOW BATTERY **
BR
Flow = 000 m3/h SC
Minutes from the
last cleaning=0000
Volume(m3) from the
last cleaning=0000
9
Advertisement
Table of Contents
