olympia electronics BS-471 Manual

BATTERY REPLACEMENT
BATTERY REPLACEMENT
The detector checks its battery voltage and transmits the information to the panel.
When the control panel displays a low battery indicator, the detector will continue to
operate for at least 2 weeks. Nevertheless it is recommended to replace the battery
as soon as possible. This must be done by a qualified technician and the control
panel must be in service mode.
I s not allowed to discard batteries in to common trash bins, they must t i
be discarded only in battery recycling points. Do not incinerate.
WARRANTY
WARRANTY
Olympia Electronics guarantees the quality, condition and operation of the goods.
The period of warranty is specified in the official catalogue of Olympia Electronics
and also in the technical leaflet, which accompanies each product. This warranty
ceases to exist if the buyer does not follow the technical instructions included in
official documents given by Olympia Electronics or if the buyer modifies the goods
provided or has any repairs or re-setting done by a third party, unless Olympia
Electronics has fully agreed to them in writing. Products that have been damaged
can be returned to the premises of our company for repair or replacement, as long
as the warranty period is valid.
Olympia Electronics reserves the right to repair or to replace the returned goods and
to or not charge the buyer depending on the reason of defection. Olympia
Electronics reserves the right to charge or not the buyer the transportation cost.
HEAD OFFICE
72nd km. O.N.R. Thessaloniki-Katerini
P.C. 60300 P.O. Box 06 Εginio Pierias Greece
www.olympia-electronics.gr
info@olympia-electronics.gr
Page 4 of 4
POWER SUPPLY
BATTERY LIFE
FREQUENCY OF COMMUNICATION
COMMUNICATION RANGE
DEGREES OF COVER PROTECTION
PRODUCED IN ACCORDANCE WITH
COMPLY WITH
OPERATION TEMPERATURE RANGE
CONSTRUCTION METERIALS
DEVICE DIMENSIONS (LxWxH)
MAGNET DIMENSIONS (LxWxH)
TYPICAL WEIGHT
GUARANTEE
GENERAL
The device BS-471 is a component of the alarm system BS-468/A. It is designed to detect
when a door or a window is opened or closed. It can also accept input from an external
magnetic contact (Normal Close). The detector is powered by battery. It consists of two items,
the electronic device and the magnet.
Front
device
LED
indicator
921471000_09_005 Page 1 of 4
BS-471
Wireless Magnetic Contact
TECHNICAL SPECIFICATIONS
CR-123A lithium battery (3V rated voltage)
> 2 Years with 20 activations per day
EN 50131-1, CLC/TS 50131-2-2, EN 50131-5-3 classification: grade 2
ETSI EN 300220, EN 50130-4, EN 55022, EN 60950-1
Thank you for your trust in our products
Olympia Electronics - European manufacturer
Plane top view
Plane base layout
Tamper
hole
Cable
hole
Mounting
holes
Figure 1
868 MHz
About 200m (open area)
IP40
ERC REC 70-03
ο
-10 to +40 C
ABS/PC
30 x 25 x 106 mm.
10 x 15 x 50 mm.
45 gr.
2 years
External
magnetic
contact
Magnetic
ON/OFF
Reaction
Immediate
Delay
Tamper
Switch
921471000_09_005