olympia electronics BS-489 Manual

BS-489
Operating Voltage
Consumption
Inputs
Outputs
User interface
Degrees of cover protection
Produced in accordance with
Operation temperature range
Humidity
Constructional materials
Dimensions ( L x W x H )
Weight
Guarantee
Thank you for purchasing this product of
O l y m p i a E l e c t r o n i c s . A E u r o p e a n
manufacturer.

GENERAL

Auto dialer BS-489 is a device that
transmits the stored messages over the
phone line when it is properly triggered.
On the front panel there is a user-
frienly control panel with 4 keys and a
display.
It is combined with all alarm panels
( e g B S - 4 1 7 , B S - 4 1 8 ) a n d w i t h f i r e
alarm panels (eg BS-632,BS-634,BS-
6 3 6 , B S - 11 6 ) m a d e
Electronics. It is also compatible with
similar products on the market. It can
be used with two different panels at the
same time, and transmits two different
messages, one for each panel. It has a
m e m o r y f o r t e n p h o n e n u m b e r s o f
twenty digits each and it is locked with
a four digit access code.
The device has a built-in microphone
f o r r e c o r d i n g m e s s a g e s , a n d a n
earphone is included in the package,
for listening the messages.
Page. 1 from 4
High Quality European based Manufacturers
Auto Dialer

TECHNICAL SPECIFICATION

Idle 10mA (24V) or 25mA (12V). Active 25mA (24V) or 70mA (12V)
2 alarm inputs and 2 messages, built-in microphone and earphone
tone or pulse call and transmission of messages through phone line
1 Display and 4 programming keys
TBR-21, EN61000-3-2, EN 61000-3-3
messages are recorded in the memory
and are not lost in case of a power
failure, and can be changed by the user
when needed.
police, the fire department, the owners
etc, in case of emergency
t h e p h o n e n u m b e r s s t o r e d i n i t s
memory, in priority (0-9) as stored by
the user. The device skips the blank
memory positions.
b y O l y m p i a
unscrewing the retaining screw at the
bottom side of the device. For wall
mounting the mounting holes on the
two corners of the device (shown on
figure 1) can be used. The appropriate
mounting screws for wall mounting, are
included.
device there are the terminal blocks
10 - 30 V DC
IP 20
ï
0 to 60 C
Up to 95% Relative Humidity
Polycarbonate
105 x 65 x 28 mm
160 gr.
2 years
A l l p h o n e n u m b e r s , s e t t i n g s , a n d
It is used to immediately call the
When triggered, the auto-dialer dials

MOUNTING

The bottom cover can be removed by

CONNECTIONS

At the bottom right side of the
921489000_09_005