H3C S3100-52P Operation Manual page 32

Operation Manual – System Maintenance and Debugging
H3C S3100-52P Ethernet Switch
The switch acts as the FTP client, and the remote PC serves as both the configuration
PC and the FTP server.
Perform the following configuration on the FTP server.
Configure an FTP user, whose name is switch and password is hello. Authorize
the user with the read-write right on the directory Switch on the PC.
Make configuration so that the IP address of a VLAN interface on the switch is
1.1.1.1, the IP address of the PC is 2.2.2.2, and the switch and the PC is reachable
to each other.
The host software switch.bin and the Boot ROM file boot.btm of the switch are stored in
the directory switch on the PC. Use FTP to download the switch.bin and boot.btm files
from the FTP server to the switch.
II. Network diagram
2.2.2.2
PC
Figure 4-2 Network diagram for FTP configuration
III. Configuration procedure
1) Configure the following FTP server–related parameters on the PC: an FTP user
with the username as switch and password as hello, who is authorized with the
read-write right on the directory Switch on the PC. The detailed configuration is
omitted here.
2) On the switch, configure a level 3 telnet user with the username as user and
password as hello. Authentication mode is by user name and password.
Note:
Refer to the Login Operation part of this manual for configuration commands and steps
about telnet user.
3) Execute the telnet command on the PC to log into the switch. The following
prompt appears:
<Sysname>
1.1.1.1
Network
4-8
Chapter 4 Device Management
Switch