H3C S3100-52P Operation Manual page 30

Operation Manual – System Maintenance and Debugging
H3C S3100-52P Ethernet Switch
Table 4-1 Interface type supported by the commonly used pluggable transceivers
Transceiver type
SFP
XFP
XENPAK
Note:
For pluggable transceivers supported by S3100-52P Ethernet switch, refer to H3C
S3100-52P Ethernet Switch Installation Manual.
Transceivers customized by H3C refer to the pluggable transceivers with the Vendor
Name field being H3C in the prompt information of the display transceiver interface
command.
Transceivers customized by H3C support display of electrical label information.
Electrical label information is also called permanent configuration data or archive
information, which is written to the storage device of a card during device debugging or
test. The information includes name of the card, device serial number, and vendor
name or vendor name specified.
Optical transceivers customized by H3C support the digital diagnosis function, which
enables a customized optical transceiver to monitor the main parameters such as
temperature, voltage, laser bias current, TX power, and RX power.
Use the following commands to display information of pluggable transceivers:
Display the current alarm
information of the
pluggable transceiver(s)
Display main parameters
of the pluggable
transceiver(s)
Display part of the
electrical label information
of the transceiver(s)
customized by H3C
Yes
Yes
Yes
To do...
display transceiver
alarm interface
[ interface-type
interface-number ]
display transceiver
interface [ interface-type
interface-number ]
display transceiver
manuinfo interface
[ interface-type
interface-number ]
Whether can be an
optical transceiver
Use the command...
4-6
Chapter 4 Device Management
Whether can be an
electrical transceiver
Yes
No
Yes
Remarks
Available for all pluggable
transceivers
Available for all pluggable
transceivers
Available for pluggable
transceivers customized
by H3C only