Machine Storage; Service And Repair; Disposal - RIDGID HC-450 Manual

Machine Storage

The Hole Cutting Tool must be kept in-
WARNING
doors or well covered in rainy weather. Store the ma-
chine in a locked area that is out of reach of children
and people unfamiliar with hole cutting tool. This ma-
chine can cause serious injury in the hands of untrained
users.

Service and Repair

WARNING
Improper service or repair can make machine un-
safe to operate.
The "Maintenance Instructions" will take care of most
of the service needs of this machine. Any problems not
addressed by this section should only be handled by
an authorized RIDGID service technician.
Tool should be taken to a RIDGID Independent Author-
ized Service Center or returned to the factory.
For information on your nearest RIDGID Independent
Service Center or any service or repair questions:
• Contact your local RIDGID distributor.
• Visit www.RIDGID.com or www.RIDGID.eu to find
your local RIDGID contact point.
• C ontact RIDGID Technical Services Department at
rtctechservices@emerson.com, or in the U.S. and
Canada call (800) 519-3456.
HC-450/HC-300 Hole Cutting Tools

Disposal

Parts of the Hole Cutting Tool contain valuable materi-
als and can be recycled. There are companies that spe-
cialize in recycling that may be found locally. Dispose
of the com ponents in compliance with all applicable
regulations. Contact your local waste management au-
thority for more information.
For EC Countries: Do not dispose of electri-
cal equipment with household waste!
According to the European Guideline 2002/ -
96/ EC for Waste Electrical and Electronic
Equipment and its implemen tation into na-
tional legislation, electrical equipment that
is no longer usable must be collected separately and
disposed of in an environmentally correct manner.
13