Cleaning Reminder; Removing And Installing Door - Zanussi ZOPND7X1 User Manual

Turn off the oven and wait
until it is cold.

CLEANING REMINDER

The oven reminds you when to clean the oven with:
pyrolytic cleaning.
PYR - flashes in the display for 10 sec after each
activation and deactivation of the oven.
, - press at the same time to turn off the
reminder.

REMOVING AND INSTALLING DOOR

The oven door has three glass panels. You can
remove the oven door and the internal glass panels
to clean them. Read the whole "Removing and
installing door" instruction before you remove the
glass panels.
The oven door may close if you try to
remove the glass panels before you
remove the oven door.
CAUTION! Do not use the oven
without the glass panels.
1. Open the door fully and hold both hinges.
2. Lift and turn the levers fully on both hinges.
3. Close the oven door halfway to the first
opening position. Then lift and pull forward and
remove the door from its seat.
When the cleaning ends:
Clean the cavity with a soft
cloth.
4. Put the door on a soft cloth on a stable surface.
5. Hold the door trim (B) on the top edge of the
door at the two sides and push inwards to
release the clip seal.
6. Pull the door trim to the front to remove it.
7. Hold the door glass panels by their top edge
and carefully pull them out one by one. Start
from the top panel. Make sure the glass slides
out of the supports completely.
8. Clean the glass panels with water and soap.
Dry the glass panels carefully. Do not clean the
glass panels in the dishwasher.
When the cleaning is completed, install the glass
panels and the oven door.
Make sure that you put the glass panels (A and B)
back in the correct sequence. Check for the
symbol / printing on the side of the glass panel,
each of the glass panels looks different to make the
disassembly and assembly easier.
When installed correctly the door trim clicks.
Remove the residue from the bot-
tom of the cavity.
2
B
1
29