Startup / Operation - BOMANN VSE7804 Instruction Manual Instruction Manual

Household - built-in larder

Hide thumbs

Table Of Contents

Table of Contents

Available languages

6 6 6 6

CAUTION

CAUTION: : : :

CAUTION

Before drilling, check the furniture front for sufficient

strength for the enclosed screw length.

1 1 1 1 Install the power cord so that the appliance can be

easily connected after installation. Slide the appli-

ance into the build-in opening until the stop plate (A)

abuts the furniture.

Open the appliance door. Push the appliance side,

which is located opposite the hinges, against the

built-in furniture. Arrange the appliance for a secure,

vertical position.

2 2 2 2 Screw the bracket (b) with the screws (S) into the

screw holes provided on the appliance door. In-

sert the guide rail (a).

Check that the merged doors are optimally

aligned vertically and horizontally so that smooth

opening and closing is guaranteed.

Mark the position of the screw holes for the guide

rail (a) on the furniture door.

3 3 3 3 Take the guide rail (a) out of the bracket (b) and

fasten the guide rail to the pre-marked position

using the screws (S) (possibly pre-drill the screw

holes).

4 4 4 4 Insert the cover (c) until it clicks in the guide (a).

5 5 5 5 Release the bracket (b) from the appliance door.

Open the appliance and furniture door completely

and bring them together. Slide the bracket (b) into

the guide rail (a) and fasten the bracket again with

the screws (S).

6 6 6 6 If an aligning of the furniture door is necessary,

use the slot spacing.

7 7 7 7 Insert the cover (d) until it clicks in the bracket (b).

8 8 8 8 Secure the appliance at the top and bottom of the

built-in cabinet with the screws (S).

7 7 7 7

8 8 8 8

9 9 9 9 Press the rubber seal (R) between the appliance

and the built-in furniture (side without hinge).

Prior to first use

CAUTION

CAUTION: : : :

CAUTION

After transport, the appliance should be left standing

upright for about four hours before connecting to the

power supply. Nonobservance could lead to malfunc-

tion of the cooling system and causes an appliance

breakdown.

Clean the appliance interior including all accessory

parts. Consider the instructions which we provide in

the chapter "Cleaning and Maintenance".

Sta

Starting the appliance

rting the appliance

• Connect the appliance to the power supply.

• Operate the temperature control. See also the

section "Settings".

Settings

Setting [ 0 ] means that the appliance is in the off

state. Turn the temperature control clockwise, start-

ing from this setting; the appliance will turn on auto-

matically.

The power levels [ 1 – 7 ] regulate the different val-

ues of the internal temperature.

Settin

Setting 0:

Settin

g 0: Off state

g 0:

Setting

Set

ting 1: 1: 1: 1: Lowest setting (warmest inside temp.)

ting

S S S S ettin

etting g g g 7 7 7 7 : : : : Highest setting (coldest inside temp.)

ettin

9 9 9 9