Single Led Fixture Hardwire Installation - Feit Electric OneSync UCL12FP/5CCTCA Important Safety Instructions And Installation Manual

Single LED Fixture Hardwire Installation

1
Turn Off the Power
Turn the power OFF from the breaker panel before
starting installation.
2
Position the Fixture
Find the desired place for the LED light fixture and mark
clearly using the provided mounting bracket template (DD).
3
Installing the Mounting Screws
Screw in the Mounting Screws (CC) on the marked locations,
leaving a gap of 0.08-0.10 inches between the screw head
and the installation surface.
4
Removing the Hardwire Bracket
Remove the screw on the hardwire bracket, then slide and
lift the bracket off of the fixture.
1
2
DD
Marked
locations
CC
3
5
Removing the Knock-out
Carefully remove the knock-out with a flathead screwdriver.
6
Installing the Clamp Connector to the
Knockout Hole
Install the Clamp Connector (HH) to the knock-out hole by inserting
it through the hole and securing it with the nut. The Clamp
Connector (HH) should be on the outer side of the bracket.
HH EE
7
Cutting and Stripping Wires
Take out the black, white, and green 18AWG wires in the
fixture. Cut and strip the wires to the correct length.
4
Please contact 1-866-326-BULB (2852) for further assistance.
EE
WWW.FEIT.COM