8.10 Programming Menu - Riello RDB2.2 FIREBIRD C20 70K DGT Installation, Use And Maintenance Instructions

8.10 Programming menu

GENERAL
The programming menu can be accessed using the reset push-
button only during OPERATION and in STAND-BY.
If in page menu the reset push-button is not pressed within 10
seconds the page will be automatically exited and there will be a
green led blinking for the value set.
BLOCK DIAGRAM FOR ENTERING THE MENU
BURNER STATE
TYPE OF
SHUT DOWN
FUNCTION TEST
5 SECS.
NUMBER OF
2 RED
BLINKS
AUTOMATIC
EXIT
EXIT
S9066
Version Release push-button time
Shut Down Test
Post Purge
Light diagnosis
Intermittent operation
Last lockout memo-
rised
20035283
Start-up, calibration and operation of the burner
OPERATION (WITH FLAME) AND STAND-BY
POST
PURGE
10 SEC.
1 GREEN
10 SEC. AFTER
RELEASE
Led signal
page menu
5s  t < 10s
2 Flashing
RED
10s  t < 15s
1 Flashing
GREEN
15s  t < 20s
2 Flashing
GREEN
20s  t < 25s
3 Flashing
GREEN
25s  t < 30s
4 blinks
GREEN
If the number of pressures on the reset push-button exceeds the
maximum allowable, the value in memory will remain the maxi-
mum one.
If the reset push-button is pressed for more than 60 seconds, a
reset push-button error will be displayed and the control-box will
restart.
LIGHT
DIAGNOSIS
15 SEC.
2 GREEN
10 SEC. AFTER
RELEASE
N° push-button
pressing
/
1 = 10 sec. (default)
2 = 20 sec.
3 = 30 sec.
4 = 60 sec.
5 = 120 sec.
6 = 0 sec. (disable)
1 = enable
2 = disable (default)
1 = 0 disable
2 = 1 hour (default)
3 = 24 hours
/
none
26 GB
INTERMITTENT LAST LOCKOUT
OPERATION MEMORISED
20 SEC.
3 GREEN 4 GREEN
10 SEC. AFTER 10 SEC. AFTER
RELEASE RELEASE
Led visualized
Exit menu
(GREEN)
Automatic from
flashing stops
1 flash 10 sec. after
2 flash release
3 flash push-button
4 flash
5 flash
6 flash
1 flash 10 sec. after
2 flash release push-button
1 flash 10 sec. after
2 flash release push-button
3 flash
Display of the 10 sec. after the
type of reset release of the but-
according to ton
table section
8.8.2
25 SEC.
Fig. 25
Tab. F