Q2: How To Select The Position Of The Slave Router ? How Does The Connection Signal Relate To The Placement Position; Q3: What Should I Do If The Bluetooth Of The Mobile Phone App Fails To Search For The Router; Q4: How To Configure Messhu Router For Pppoe Network - Fujitsu MESSHU RT500 Faq

Q2: How to select the position of the Slave Router ? How does the connection
signal relate to the placement position ?
A: One RT500 supports approximately 1500 square feet of space. If there is more obstruction
or signal interference in the home, the support space will be reduced.
If the RT500 is placed, the RT500 white light is on, indicating that the placement distance is
moderate and the connection is successful.
If orange or red lights appear on the RT500, it indicates that the connection is unstable. Please
try to relocate the RT500 to a different place or close to another RT500. Try not to place it in a
more closed space.
Each RT500 is best placed within a distance of 10m, and the smaller the distance between
straight lines is better. Because the walls will weaken the WiFi signal, the material of the
building will also affect the efficiency of wireless signal transmission. If there are many other
WiFi signals or wireless devices (such as a wireless phone in the house) around the house,
different signals interfere with each other, which affects the WiFi signal transmission
performance and speed.
Please turn off other WiFi devices you don't need (such as wireless sharer and WiFi extender)
as much as possible to ensure that the RT500 can use the best WiFi power
It is recommended to re-start all RT500 (master + slave) after placing a new location, wait for
about 10 minutes for the system to restart and optimize the network, and then check the signal
and try network again
Mesh network can provide better WiFi coverage for using three or more RT500, such as in a
high-rise house or a larger area, and can increase WiFi coverage by adding RT500
Q3: What should I do if the Bluetooth of the mobile phone APP fails to search
for the Router ?
A: Please turn off the Bluetooth of your mobile phone and turn it back on again, and keep it within
3 meters from the Router.
If the Router is connected to the power supply for more than one hour, remove the power and
restart it again.
# If you are using an Android phone, please turn off "Power Save" and turn on "GPS Location"

Q4: How to configure MESSHU Router for PPPoE network ?

A: During the first installation, it will show that no network can be detected, and then prompt to
manually set the ID & Password
See supplemental instruction: Start Setting Step 12
9