Base Unit Installation - V2 WES-ADI Instruction Manual

BASE UNIT INSTALLATION

PLEASE NOTE: disconnect the power to the main control unit prior to inserting the WES-ADI device
1. Insert the WES-ADI module into the specific connector.
2. Power up the control unit and ensure that the green LED on the base unit is flashing normally after a few seconds. If the red LED
remains on, this means the base has already been configured; it is necessary to delete the old configuration (see the section on
RESETTING THE BASE UNIT CONFIGURATION)
NOTE: when the device is powered up, up to 15 seconds may be required before the connection with all sensors is
re-established. The system is ready for use when the LEDs for all the sensors are flashing at the scanning frequency set.
L1 - GREEN LED
L2 - RED LED
L3 - YELLOW LED
POSITION 1
11
POSITION 2