Ignition 2bright Blind 3K User Manual page 31

Brightness of LEDs
Master / slave mode
In this menu you can set the brightness of LED 1 and LED 2.
Press [MENU] repeatedly until the display shows 'STAT' . Use [UP] or [DOWN] LED 1 or LED 2 off
(display shows 'LED1' or 'LED2' ). Confirm the selection with [ENTER]. Press again [ENTER] to
make changes. Use [UP] or [DOWN] to select a value between 0 and 255 to adjust the bright‐
ness of the selected LED (display shows '000' ... '255' ).
Confirm the selection with [ENTER].
In this menu, you can specify whether the device is operating slave mode.
Press [MENU] repeatedly until the display shows 'SLAV' . Confirm the selection with [ENTER].
Use [UP] or [DOWN] to select the option 'Yes' to use the device as slave.
Confirm the selection with [ENTER].
The device is now working in slave mode, i.e. it will exactly copy the movement of the control‐
ling master device, correct wiring provided.
Operating
2bright Blind 3K
31
blinder