Transportation - Woods BH85 Operator's Manual

Figure 13. Thumb Storage Position
TRANSPORTING
 Always engage swing, stabilizer and boom
transport locks and attach Slow Moving Vehicle
(SMV) sign before transporting backhoe.
 Turn on tractor's flashing lights when transport-
ing.
 Power unit must be equipped with Roll Over
Protection System (ROPS) or ROPS cab and seat
belt. Keep seat belt securely fastened. Falling off
power unit can result in death from being run over
or crushed. Keep foldable ROPS system in "locked
up" position at all times.
 Never leave equipment unattended with engine
running or with bucket in raised position. Always
engage swing, stabilizer and boom transport locks,
Relieve system pressure by operating controls,
and remove ignition key before leaving equipment.
Transport and Swing Lock Installation
Install Transport Lock Pins
1. Retract boom and dipper to the transport position
(boom fully raised, dipper back, and bucket fully
curled).
2. Center boom from side to side and install swing
lock pin through swing frame and main frame.
Secure with klik pin. See Figure 14.
18 Operation
ARNING
3. Install transport lock pin through boom and swing
frame and secure with lock pin.
4. Always raise and
transporting backhoe. See Figure 14.
Figure 14. Lock Pins Installed for Transportation
Pin Storage
1. Store swing and boom lock pins in holes on rear of
console during operation. Install lock pin and klik
pin, Figure 15.
2. Store stabilizer lock pins in main frame. See Figure
15.
Figure 15. Pin Storage Position
IMPORTANT: Before operating backhoe, disengage
transport lock pin and swing lock pin. Place pins in stor-
age position and secure with lock pins provided.
lock stabilizers before
MAN1272 (10/22/2019)