Baofeng DM-V1 Programming Manual page 15

Scan Alias
Available
Members
Designated TX channel
Priority Channel 1
Priority Channel 2
Hang Time
Priority Sweep Time
Talkback
Note:
You can add the same channel to multiple scan lists.
Picture 18: Scan List
Name given to group of scanned channels
Will list the channels available to scan
List of channels to be scanned
This feature defines the conventional channel/trunking personality on which the radio will
transmit if the user presses the Push-to-Talk (PTT) button while the radio is scanning.
Sets which channel is priority 1
Sets which channel is priority 2
Sets the amount of time that the radio waits on an analog scan list channel when a carrier signal
of sufficient amplitude is detected on the channel. This pause allows the radio to decode the
analog system signaling data. If the decoded information is incorrect, the radio reverts to scan.
Sets the duration that the radio waits, when in a call, before scanning the priority channels. If
the call is taking place on a Priority 1 Channel, no scanning will take place. When scanning
priority channels, the radio briefly mutes the current transmission. Increasing this interval
improves the audio quality of the current transmission as fewer checks are done, but this also
increases the chance of the radio missing out priority channel activity.
Determine if the user can transmit on the channel on which it sounds during the scan.