Master Section; Microphone Section - Vestax PMC 250 Owner's Manual

u HI CUT (Fader type cut switch HI)
When this volume is set to bottom position, high
frequency range is cut of completely regardless
of the position of the HI level control. The HI
level control knob becomes active when this
volume is set to maximum （top） position.
i MID CUT (Fader type cut switch MID)
When this volume is set to bottom position, mid
frequency range is cut of completely regardless
of the position of the MID level control. The MID
level control knob becomes active when this
volume is set to maximum （top） position.

MASTER SECTION

!1 POWER INDICATOR
The LED light when the power is on.
!2 LED LEVEL METER
The bar graph level meters indicate the master
output level （L channel and R channel） or input
level of each program （program 1 and 2） .
!3 METER SELECT
When this switch is set to MASTER, the bar-
graph meter indicates the master output level （L
channel and R channel） . When it is set to
PGM, the left meter shows the input level of
PGM1 and the right meter shows the input level
of PGM2.
!4 AUX (AUX level volume)
Used to adjust the Input level of AUX IN.

MICROPHONE SECTION

INPUT LEVEL
18
+6 +3 +2 +1
Lch
12
MIC
FILTER
MIN MAX MIN
19 20
o LOW CUT (Fader type cut switch LOW)
When this volume is set to bottom position, low
frequency range is cut of completely regardless
of the position of the LOW level control. The
LOW level control knob becomes active when
this volume is set to maximum （top） position.
!0 INPUT FADER
Used to adjust the input level of each program.
Please replace with IF-250 when it is worn out,
or with the optional rotary fader unit.
0 -1 -2 -4 -7 -10 -20 -30
PGM 1
AUX
14
MIN
MASTER
15
MIN
1
!5 MASTER (MASTER level volume)
Adjusts the output level of LINE OUT and PA
OUT.
!6 BOOTH OUT
Adjusts the output level of BOOTH OUT.
!7 CROSS FADER
The signal from PGM1 is output when the cross
fader is set to the left side. The signal from
PGM2 is heard when the cross fader is set to
the right side. When the cross fader is set at
centre position, both programs will be mixed
and output at the same time. Please replace it
with the CF-PCV when it is worn out.
!8 MIC INPUT (Mic Input Jack)
Input jack for the microphone.
!9 MIC LEVEL (Mic Level Volume)
Adjusts the input level of the microphone.
@0 MIC FILTER (Mic Filter Volume)
Adjusts the cut off frequency of the microphone
MAX
input. It is used to prevent low frequency noise
such as breathing, vibration, etc.
5
11
PRO FESSIONAL MIXING CONTROLLER
POWER -30 -20 -10 -7 -4 -2 -1 0 +1 +2 +3 +6
METER SELECT
MASTER PGM
MAX
BOOTH OUT
MAX MIN MAX
PGM 2 LEVEL
2
Rch PGM 2
13
16
17