KERN HFC Service Manual page 28

How to carry out adjustment:

Confirm adjustment function "Commo" by

"ULoAd" will be displayed. Make sure that no loads
apart from the lifting tackle are attached to the hook.

Wait for stability display, then press
Either use the displayed adjustment weight or change
by and
flashing.
To change the selected (flashing) digit, press
repeatedly until the desired value is displayed. Then
select further digits by
.

, „LoAd" will be shown.
Confirm by

Attach adjustment weight. Wait for stability display,
then press .

After successful adjustment „Pass" will be displayed.
Afterwards the balance will carry out a self-test.
"Err19" will appear briefly (Ignore error message), then
the balance will change automatically into weighing
mode and the total weight will be displayed.
Adjustment has now been completed successfully.

In case of an adjustment error or incorrect adjustment value the error message
"fail" will be displayed and you must repeat the adjustment procedure.
28
.
, the currently enabled digit is
and amend them by
.
(example)
(example)
HFC-SH-e-1510