Oki ColorPainter M-64S User Manual page 46

2
Left Margin
(2)
Right Margin
Edge Guards
Color Stripe Bar
Left Margin
Right Margin
Follow the procedure below to enter the correct paper size and margin values on the RIP and Print screen that is
displayed during printing.
(1) Click the Poll Size button to acquire the width value of the roll media installed to the printer.
š The acquired width value is the roll width and is not the width of the printable area. The width of the printable area
(2) Refer to the table to enter the left and right margin values in the corresponding fields on the RIP and Print screen.
The margin values must match the Edge Guards and Color Stripe Bar settings of the media preset currently
applied.
š Pay particular attention when using options such as Fit to media, Place the image at the roll center, or Align
š If you want to select Fit to media, select it after entering the values in steps (1) and (2).
š If you select Centering with different values for the right and left margins, the printed image will be centered based
46
Printing on reflective sheeting
On
Off
1.000cm
1.000cm
can be correctly defined by setting the values of the left and right margins in addition to the roll width.
efficiently multiple images since the edges of the printed image may be clipped if the paper size and the right and
left margins are not set correctly.
on the printable area width and not on the media physical width.
(1)
(3)
On Off
On Off
3.260cm 0.500cm
1.000cm 0.500cm
Off
On
2.760cm
0.500cm