Cloning - Yaesu FT-60R Operating Manual

The FT-60R includes a convenient "Clone" feature, which allows the memory and con-
figuration data from one transceiver to be transferred to another FT-60R. This can be
particularly useful when configuring a number of transceivers for a public service opera-
tion. Here is the procedure for Cloning one radio's data to another:
1. Turn both radios off.
2. Connect the optional CT-27 Clone Cable between the MIC/SP jacks of the two ra-
dios.
3. Press and hold in the MONI switch (just below the PTT switch)
while turning the radios on. Do this for both radios (the order of
switch-on does not matter).
4. Rotate the DIAL job on each radio to select to "F8 CLONE,"
then press the [ F/W ] key momentarily.
5. The display will disappear for a moment, then the "CLONE"
notation will appear on the displays of both radios when the
Clone mode is successfully activated in this step.
6. On the Destination radio, press the MONI switch ("--RX- -" will
appear on the LCD).
7. Press the PTT switch on the Source radio; "- -TX- -" will appear
on the Source radio, and the data from this radio will be trans-
ferred to the other radio.
8. If there is a problem during the cloning process, "ERROR" will
be displayed. Check your cable connections and battery volt-
age, and try again.
9. If the data transfer is successful, "CLONE" will reappear on both
displays. Turn both radios off and disconnect the cloning cable. You can then turn the
radios back on, and begin normal operation.
FT-60R O
MIC/SP
CT-27
M
C
LONING
MIC/SP
65