Safety /Warning Information; Safety Training Information; Antenna Installation - Vertex Standard VX-2100E Series Operatiing Manual

Fm transceiver
Table of Contents

Advertisement

You now have at your fingertips a valuable communications tool: a VERTEX STAN-
DARD two-way radio! Rugged, reliable and easy to use, your VERTEX STANDARD
radio will keep you in constant touch with your colleagues for years to come, with
negligible maintenance downtime.
Please take a few minutes to read this manual carefully. The information presented
here will allow you to derive maximum performance from your radio, in case ques-
tions arise later on.
We're glad you joined the VERTEX STANDARD team. Call on us anytime, because
communications is our business. Let us help you get your message across.
WARNING - DO NOT operate the VX-2100E radio when any person(s)
(bystanders) outside the vehicle are within the distances shown in the chart
at the bottom of this section.

Safety Training Information:

Antennas used for this transmitter must not exceed an antenna gain of 0 dBd.
The radio must be used in vehicle-mount configurations with a maximum
operating duty factor not exceeding 50 %, in typical Push-to-Talk configura-
tions.
This radio is restricted to occupational use, work related operations only
where the radio operator must have the knowledge to control the exposure
conditions of its passengers and bystanders by maintaining the minimum
separation distance shown below.

Antenna Installation:

For rear deck trunk installation, the antenna must be located at least the
following distance away from rear-seat passengers.
For roof top installations, the antenna must be placed in the center of the roof.
Warning!
The 50.0 V RF voltage (@25 W/50 Ω) is applied to the antenna terminal of
the transciver while transmitting.
Do not touch the TX RF section absolutely while transmitting.
Caution: The radio can become hot.
Do not operate the radio continuously in transmission mode for longer than
7 minutes. Ensure enough standby/reception time for cool-down between
transmission periods. Be sure that TOT timer is correctly installed and prop-
erly working. Avoid touching the rear bottom of the transceiver's body while
transmission.
Congratulations!
S
/W
AFETY
Unsafe Radiation Distance
VHF Model
25 W
I
ARNING
NFORMATION
1 m
UHF Model
0.8 m

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vx-2200e series

Table of Contents