Internet Connection Feature - Yaesu FT-2800M Operatiing Manual

I
NTERNET
The FT-2800M can be used to access an Internet link on a repeater which is equipped for
operation using the Vertex Standard WIRES
ment System) Internet linking system.
1. Press the [ ] key to activate the Internet Connection feature. The "int" icon will appear
in the memory channel field.
2. Rotate the DIAL, while pressing and holding in the
[ ] key, to select the access number correspond-
ing to the WIRES
establish an Internet link (ask your repeater owner/operator if you don't know the access
numbers in the network).
3. With the Internet Connection feature activated (as in step 1 above), the FT-2800M will
generate a brief (0.2 second) DTMF tone according to your selection in step 2. This
DTMF tone is sent at the beginning of every transmission to establish or maintain the
link to the remote WIRES
Group") mode.
4. To disable the Internet Connection feature, press the [
For more information on WIRES
chures/WIRES.pdf
You may access other Internet Link Systems that use a DTMF string for access.
1. Press and hold in the [ MHz ( SET )] key for one second, then rotate the DIAL knob to
select "10 DT MEM."
2. Press the [ MHz ( SET )] key momentarily, then load the DTMF tones which you wish to
use to establish an Internet link (the linking system's Home Page should have this infor-
mation) into the desired DTMF Memory channel.
1). Rotate the DIAL knob to select the DTMF Autodialer memory channel number
("DTMF-1" through "DTMF-9").
2). Press the [ D/MR ( MW )] key momentarily.
3). Rotate the DIAL knob to select the DTMF code, then press the [ REV ( DW )] key
momentarily to move the digit.
4). Repeat step 3) above as many times as needed to complete the access string.
5). Press the [ MHz ( SET )] key momentarily to save the new setting.
3. Rotate the DIAL knob to select "13 INTNET."
4. Press the [ MHz ( SET )] key momentarily, then rotate the DIAL knob to set this item to
"LINK" (to enable the alternate Internet Link, and disable the WIRES
5. Press and hold in the [ MHz ( SET )] key for one second to save the new setting and exit to
normal operation.
6. Press the [ ] key momentarily to activate the Internet Link System. The "int" icon will
then appear in the memory channel field while the Internet Link System access feature is
engaged.
FT-2800M O
PERATING
TM repeater to which you wish to
TM repeater, while operating in the "SRG" ("Sister Repeater
TM , go online to
for an informative brochure. Or send an e-mail to
M
ANUAL
C
ONNECTION
TM (Wide-Coverage Internet Repeater Enhance-
http://www.yaesu.com/amateur/pdf/bro-
F
EATURE
] key again.
WIRES@vxstdusa.com
TM access option).
.
41