Separate Transmit Frequency Memory ("Odd Splits") - Yaesu FT-2800M Operatiing Manual

[ 3 ] Separate Transmit Frequency Memories ("Odd Splits")
All memory channels can store independent receive and transmit frequencies, to accommo-
date occasional non-standard offsets with greater frequency resolution than is available us-
ing the "standard" shift feature.
1. First store the receive (repeater output) frequency. In the VFO mode, tune the transceiver
to the desired receive frequency. Now press and hold in the [ D/MR ( MW )] key on the
front panel for one second.
2. Within five seconds of pressing the [ D/MR ( MW )] key, use the DIAL knob or microphone's
[ UP ] / [ DWN ] buttons to select the desired memory channel into which you wish to store
this frequency pair.
3. Now press the [ D/MR ( MW )] key momentarily to store the receive frequency into the
selected memory.
4. Next store the transmit (repeater input) frequency. Since you are still in the VFO mode,
tune the transceiver to the desired transmit frequency.
5. Now press and hold in the [ D/MR ( MW )] key for one second.
6. Press and hold in the PTT switch, and press the [ D/MR ( MW )] key momentarily while
holding in the PTT switch. This will not cause transmission, but rather it will instruct the
transceiver that you are programming a separate transmit frequency into memory.
When you have finished the above procedure, press the [ D/MR ( MW )] key momentarily.
The channel number and repeater downlink frequency will appear on the display. If you
press the PTT switch, you will observe the display changing to indicate the repeater's uplink
frequency. Note also that the display shows "
cates that an "odd" (non-standard) shift has been stored on this channel.
FT-2800M O
PERATING
A
DVANCED
R O
EPEATER
M
ANUAL
O
PERATION
" in the upper left-hand corner; this indi-
PERATION
23