Cisco Catalyst 3650 Series Hardware Installation Manual page 87

Chapter 4 Power Supply Installation
Figure 4-11
Step 5 Use the ground screw to attach the single-hole ground lug to the switch's rear panel. Use two ground
screws to attach the dual-hole lug to the switch's rear panel
Using a ratcheting torque screwdriver, torque the ground-lug screws to 60 lbf-in. (960 ozf-in.).
Step 6
Step 7 Connect the other end of the grounding wire to an appropriate grounding point at your site or to the rack.
Figure 4-12
1 Single-hole ground screw and lug ring
OL-29734-01
Crimping the Ground Lug
Attaching the Ground Lug and Wire Assembly
1
2
Installing a DC Power Supply
(Figure 4-12).
2 Dual-hole ground adapter and dual-hole lug
Catalyst 3650 Switch Hardware Installation Guide
4-11