Cisco Catalyst 3650 Series Hardware Installation Manual page 125

Appendix 3 Configuring the Switch with the CLI-Based Setup Program
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity
for management of the system, extended setup will ask you
to configure each interface on the system.
Would you like to enter basic management setup? [yes/no]: yes
Enter a host name for the switch, and press Return.
Step 2
On a command switch, the host name is limited to 28 characters, and to 31 characters on a member
switch. Do not use -n, where n is a number, as the last character in a host name for any switch.
Enter host name [Switch]: host_name
Enter a secret password, and press Return.
Step 3
The password can be from 1 to 25 alphanumeric characters, can start with a number, is case sensitive,
allows spaces, but ignores leading spaces. The secret password is encrypted, and the enable password is
in plain text.
Enter enable secret: secret_password
Enter an enable password, and press Return.
Step 4
Enter enable password: enable_password
Enter a virtual terminal (Telnet) password, and press Return.
Step 5
The password can be from 1 to 25 alphanumeric characters, is case sensitive, allows spaces, but ignores
leading spaces.
Enter virtual terminal password: terminal-password
To configure the country code, enter yes and press Return.
Step 6
Do you want to configure country code? [no]: yes
Enter the country code, and press Return.
Step 7
Enter the country code[US]:US
Step 8 (Optional) Configure Simple Network Management Protocol (SNMP) by responding to the prompts. You
can also configure SNMP later through the CLI, Device Manager, or the Cisco Network Assistant
application. To configure SNMP later, enter no.
Configure SNMP Network Management? [no]: no
Enter the interface name (physical interface or VLAN name) of the interface that connects to the
Step 9
management network, and press Return.
Enter interface name used to connect to the
management network from the above interface summary: vlan1
Step 10 Configure the interface by entering the switch IP address and subnet mask and pressing Return. (The IP
address and subnet masks shown here are examples.)
Configuring interface vlan1:
Configure IP on this interface? [yes]: yes
IP address for this interface: 10.4.120.106
Subnet mask for this interface [255.0.0.0]: 255.0.0.0
OL-29734-01
Entering the Initial Configuration Information
Catalyst 3650 Switch Hardware Installation Guide
3-7