Battery Installation - Vermont Castings Signature VC3624GS Assembly And Owner's Manual

Locate these parts:
Zip Tie
1. Using the zip tie, secure the hose to the front leg
as shown. Do not pull the zip tie tight - leave it just
loose enough so that the hose can be adjusted if
needed.
Tying the hose to the leg helps prevent the hose from coming into contact with the hot
burner chamber. Inspect the installation underneath the smoker to ensure that the
hose is not rubbing any portion of the burner chamber.
2. Place one end of the S-Hook around the
regulator neck or through the eyelet as shown.
3. Using pliers, crimp the S-Hook securely to the
HVR so that it can not be removed from the HVR.
4. When an LP tank is not attached to the smoker,
use the S-Hook to hang the HVR from the carry
handle on the side of the smoker. This will help
prevent dirt and other particles from plugging the
end of the HVR.
5. Unscrew the button cap off of the ignitor button
and remove the cap and spring.
6. Insert the "AAA" battery, negative end first, into the
ignitor module and replace the spring and cap.
Assembly Step 9
F
HARDWARE BAG
S-Hook
Crimp
OR
G
HARDWARE BAG
"AAA"
Battery
12
Tools needed:
Pliers
S-Hook
Zip Tie