Attach The Carry Handles - Vermont Castings Signature VC3624GS Assembly And Owner's Manual

Locate these parts:
3 Damper Plates
Hardware:
10-24x5/8" Bolts
3 Required
Assembly Step 5
HARDWARE BAG
10-24 Lock
Washers 10-24 Nuts
3 Required 3 Required
2 Carry
Handles
B
HARDWARE BAG
1/4-20 Nuts
4 Required
1. For each damper plate, line it up with
the damper openings on the outside
of the smoker cabinet.
2. Insert a 10-24x5/8" bolt into the center
mounting hole from the outside of the
smoker.
3. From the inside of the smoker cabinet,
thread on a lock washer and nut.
Slightly tighten the nuts, but allow them
to stay loose enough to freely rotate the
damper plates.
4. For each carry handle, insert the
mounting studs into the mounting
holes on the sides of the smoker
cabinet.
5. From the inside of the smoker cabient,
thread on a nut onto each mounting
stud. Securely tighten the nuts.
There are 3 damper locations and 2 carry
handle locations - repeat steps until all are
assembled.
8
Tools needed:
Phillips Head
Screwdriver
C
1/2"
Wrench