Faqs And Troubleshooting Guide - Akai AK-95WM Instruction Manual

FAQs and Troubleshooting Guide

Error messages
When the following problems occur, the microcomputer inside the washer will detect
the errors. An electronic buzzer will sound for approximately 10 seconds, an error
message will flash, as shown below, and the washer will stop operating.
Problem
The washer is
not filling with
water.
Water is not
draining.
The washer
will not start.
The washer
does not spin.
20
(AU) 1300 886 649 (NZ) 0800 836 761 |
Error Possible Diagnosis
• Inlet taps are not
turned on.
• Blocked inlet hose
filters.
• Delay Start is set.
• The drain hose is not
properly connected or
installed.
• The drain hose is
kinked or obstructed.
• The drain hose is
clogged.
• The drain pump lint
filter at the lower rear
of the machine is
clogged.
• This lid is not closed
properly.
• The load could be out
of balance.
After Sales Support
Possible Solution
• Check that both the hot and
cold taps are turned on.
• Clear blockages from inlet
hose filters.
• Refer to page 19 for
information about the
Delay Start function.
• Check the drain hose
connection (see page 9).
• Check the drain hose
connection (see page 9).
• Disconnect the hose and
check for obstructions.
• Clear the drain pump lint
filter (see page 24).
• Check and ensure that the
lid is closed.
• Pause the washer and
manually redistribute the
load.
• Check and ensure that the
washer is level and does
not rock in any direction
(see page 12).
• Check and ensure that no
suds have built up in the
washer.
info@tempo.org