Akai AK-95WM Instruction Manual page 19

Instructions (Cont.)
Preset washing (delayed start)
This feature can delay the start of the washing program by 1 hour up to 24 hours.
• Press the ON/OFF button to turn the machine on and follow the previously outlined
steps for adding your wash load, selecting the desired program and adding the
required detergent / fabric softener.
• Close the lid and ensure it is closed properly.
• Press the Delay button once to delay the start by one hour, twice by two hours and
so on. The maximum amount of time you can delay the start is 24 hours.
• Once you have selected your desired delay start setting, press the Start/Pause
button to confirm the delay start. The indicator light will flash on the control panel
until the program begins.
• The program will automatically commence following the selected delay setting.
• To cancel the delay start setting, simply press the ON/OFF button to turn the
machine off and then press it again to turn the machine back on.
NOTE: When using the delay start feature, we recommend that you use detergent
powder as opposed to liquid detergent. Do not add detergent directly onto the clothes
in the washing tub as it may damage clothing.
Automatic power-off feature
If you do not start a washing program within 10 minutes after switching the machine
on, it will automatically switch off. Simply press the ON/OFF button to restart the it.
Automatic imbalance correction feature
• When your washer is spinning, it can sense if the wash load is out of balance. If the
laundry is placed in the tub unevenly before the wash process begins, it is likely
that it will cause vibration during operation. The washing machine is continuously
checking for imbalance during operation, and if the spinning vibration is too great,
the machine will automatically start adjusting the program to correct the imbalance.
• When the machine detects imbalance and begins the adjustment of a program, the
rinse light will flash and the machine will begin to inject water to increase the water
level. The machine will continue this process automatically for approximately one
minute and then drain the water, returning to the original spinning state.
• If the washing machine attempts the autocorrection twice and cannot correct the
balance, an alarm will sound and the machine will stop. At this point, you will need
to open the lid and manually redistribute the wash load creating an even balance.
• Press the Start/Pause button to resume the washing process.
Power failure memory function
If your home's power supply is unexpectedly cut off during operation, the machine will
remember where it was up to in the program cycle process. When the power supply is
returned, the machine will automatically resume at the same place is was interrupted
prior to the power outage.
(AU) 1300 886 649 (NZ) 0800 836 761 |
After Sales Support
info@tempo.org
19