Akai AK-95WM Instruction Manual page 10

Installation (Cont.)
Connecting the water inlet hoses
Install the water inlet hoses to your hot and cold water taps, following the instructions
below.
• Check and ensure that the sealing washers are firmly in place.
• Attach the straight end of the hose to your water taps. Make sure to attach the hot
water supply hose (with a
hose (with a
• Tighten the coupling nuts securely by hand, as illustrated below:
• Attach the curved end of the hose to the corresponding inlet valve of the washing
machine.
• Tighten the coupling nuts securely by hand, as illustrated below:
• Tighten the nut by turning it clockwise while holding the hose. (To detach the water
supply hose, turn the nut anticlockwise after turning the tap off.)
• Turn on the taps and check for leaks. Tighten the coupling nuts firmly if there is any
leakage. If your water pressure is strong, close the water tap completely, then open
it slightly.
• Make sure your hot water from the tap is no hotter than 60°C.
Both the hot water and cold water hoses must be connected to your taps.
10
(AU) 1300 886 649 (NZ) 0800 836 761 |
red stripe) to the hot water tap and the cold water supply
blue stripe) to the cold water tap.
Tap
Sealing
Washer
Tap End
Inlet Hose
After Sales Support
Twist
IMPORTANT!
info@tempo.org