New Construction Installation Instructions - HOME NETWERKS 7130-13-BT Instructions Manual

NEW CONSTRUCTION INSTALLATION INSTRUCTIONS

BEFORE INSTALLATION
WARNING: RISK OF ELECTRIC SHOCK. Ensure the electricity
to the wires you are working on is shut off. Either remove the
fuse or turn off the circuit breaker before removing the existing
bath fan or installing the new one.
1. Installation Without Suspension Brackets
Place the fan body next to a ceiling joist. The fan housing
should be level and perpendicular to the joist. Allow for
thickness of ceiling board used in your application. DO
NOT flush mount to joist. Bottom of fan should be flush
with ceiling board.
2. Mount fan body to the joist or stud using wood screws (AA)
where indicated by arrows outside fan body.
3. Installation With Suspension Brackets
Insert suspension bracket onto fan housing using suspension
bracket I and II. Position fan housing so edge of fan is flush
with sheetrock. Do not flush mount housing with joist.
Mounting with joist spacing of 12 in. to 24 in.
4. Fig. 4A - Secure the fan housing to joist with suspension
brackets using M4x30 wood screws (AA) (included).
(Joist spacing of less than 21-1/4 in.)
Fig. 4B - Mounting with joist spacing of 21-1/4 in. to 23-1/2 in.
1
2
3
4
6
Fig. 1
4A
4B
HomewerksWW.com