Table of Contents
Advertisement
EXISTING CONSTRUCTION INSTALLATION INSTRUCTIONS (continued)
4. Position fan housing so edge of fan is flush with ceiling board/
sheetrock. Do not flush mount housing with joist.
NOTE: HOUSING MUST BE INSTALLED FLUSH WITH
CEILING BOARD/SHEETROCK OR THE GRILLE MOUNTING
SPRING WILL NOT BE LONG ENOUGH TO INSERT INTO
THE SLOTS INSIDE THE FAN HOUSING.
5. Fig. 5A - Secure the fan housing to joist with suspension
brackets using M4x30 wood screws (AA) (included).
(Joist spacing of less than 21-1/4 in.)
Fig. 5B - Mounting with joist spacing of 21-1/4 in. to 23-1/2 in.
6. Secure the suspension bracket (C) to fan housing using
screw (CC) (included). Secure suspension brackets (D, E)
with screws (BB) (included).
7. Remove junction box cover as shown in illustration number 7.
Using quick connect ports, connect house wires to the switch
and fan. Please refer to the wiring diagram on page 5 to ensure
proper wire connections are being made.
Note: Do not use metal wall plate with the switch, as it may
cause interference with the fan operation.
ATTENTION: The switch included with this ventilation fan
requires a neutral wire connection. If a neutral line is not
present, one must be run by a qualified electrician.
If you require assistance, please call 1-877-319-3757 before
attempting switch installation.
NOTE: This switch is intended to only operate independently
with this bath fan. Connections to other electrical fixtures are
prohibited and could cause electrical issues.
HomewerksWW.com
4
5
6
7
9
5A
5B
Hide quick links:
Advertisement
Table of Contents
