Sending Everything; Transferring Measurement Data Via Bluetooth To "Tpa Startcenter; Transferring Measurement Data Via Usb To "Tpa Startcenter; Settings - Bosch TPA 200 Original Instructions Manual

en 28 | TPA 200 | Operation
5.7

Sending everything

The measurement data saved in the TPA 200 can
be transferred via Bluetooth or via the USB. The
prerequisite is that the "TPA Startcenter" soft-
ware has been started on a PC/laptop.
5.7.1 Transferring measurement data via
Bluetooth to "TPA Startcenter"
i
Searching and displaying Bluetooth devices
(see sec. 5.8.2.).
1. Start the "TPA Startcenter" software.
2. Switch on the TPA 200.
 Main Menu
is displayed.
 Check
is displayed.
3. Select "Send All Data" with
confirm with .
 Bluetooth Activated
 Connecting...
 Saved measurement data is sent to "TPA
Startcenter".
 Bluetooth Deactivated
5.7.2 Transferring measurement data via
USB to "TPA Startcenter"
1. Start the "TPA Startcenter" software.
2. Switch on the TPA 200.
3. Connect the TPA 200 to a PC/laptop via the
USB connecting cable.
 The Charging...
short time on the TPA 200
 After some time there appears on the PC/
laptop the message
ments have been found on the
TPA. Import?
4. Select <Yes>.
 The measured values are imported.
5.8

Settings

The following settings can be selected.
Function Description

General

Select menu language, specify opera-
tion sequence, delete automatically or
select activate/deactivate Bluetooth
and mode

BT Pair

Bluetooth devices are found and dis-
played.
Info The software version with the version
date and serial number of the TPA
200 is displayed.
Update The software update can be per-
formed (the update deletes all the
measured values which have been
saved)
|
1 689 989 200 2016-02-16
or and
is displayed.
is displayed.
is displayed.
message appears for a
Sensor measure-
5.8.1 General
Language
The menu language can be selected.
Workflow
See sec. 5.2.
Auto Delete
The TPA 200 can save a maximum of 99 measured
values. If the option for Auto Delete is activated,
the first measured value is deleted automatically
as from the hundredth measured value. If the
function is deactivated, the message appears on
Memory Full. Delete all mea-
the display
sured values and continue measuring?
Bluetooth
Bluetooth is always activated as standard. Blue-
tooth must be deactivated in order to transfer
the saved data via the USB connecting cable.
The "Send All Data" menu item is masked out in
the main menu.
Mode
Startcenter or F.I. (Entrance Check) can be
selected. With the Startcenter mode, the saved
measurement data can be transferred from
TPA 200 to "TPA Startcenter" (see sec. 5.7). The
Startcenter mode is set by default.
With the F.I. mode, TPA 200 can be linked to the
"Entrance Check" software via Bluetooth. In this
way, measurement data are transferred directly
after each measurement.
i
The "Entrance Check" software is available
only to certain workshops. If the "Entrance
Check" software is not available, the Start-
center mode must be selected.
5.8.2 BT Pair
This function enables you to search and display
the Bluetooth devices, which are in the locality.
The Bluetooth device (PC/laptop), on which the
"TPA Startcenter" software is installed, must
then be selected. The saved measured values of
the TPA 200 can then be transferred onto the
PC/laptop from the main menu under "Send
everything".
Robert Bosch GmbH