9-Troubleshooting - Haier HW70-B1239 User Manual

9-Troubleshooting

0DQ\ RFFXULQJ SUREOHPV FRXOG EH VROYHG E\ \RXUVHOI ZLWKRXW VSHFL F H[SHUWLVH ,Q FDVH
of a problem please check all shown possibilities and follow below instructions before you
FRQWDFW DQ DIWHU VDOHV VHUYLFH 6HH &86720(5 6(59,&(
WARNING!
▶ Before maintenance, deactivate the appliance and disconnect the mains plug from
the mains socket.
▶ (OHFWULFDO HTXLSPHQW VKRXOG EH VHUYLFHG RQO\ E\ TXDOL HG HOHFWULFDO H[SHUWV EHFDXVH
improper repairs can cause considerable consequential damages..
▶ A damaged power cable should only be replaced by the manufacturer, its service
DJHQW RU VLPLODUO\ TXDOL HG SHUVRQV LQ RUGHU WR DYRLG D KD]DUG
9.1 Information codes
Following codes are displayed only for information referring to the washing cycle. No
measures must be performed.
Code Message
The remaining wash cycle time will be 1 hour and 25 minutes
:
The remaining wash cycle time including chosen end-time delay will be 6 hours and 30 min-
:
utes
 DGGLWLRQDO ULQVHV DUH FKRRVHQ VHH )81&7,21 %877216 ([WUD ULQVH 
3//
7KH ZDVKLQJ F\FOH LV QLVKHG 7KH DSSOLDQFH VKXWV R DXWRPDWLFDOO\
(QG
Function Child Lock is activated
Door is closed because of high water level, high water temperature or spinning cy-
/RF, 
cle.
The buzzer is deactivated
E((3 2))
The buzzer is activated
E((3 21
Function "Speed up" is activated
63((G u3
 7URXEOHVKRRWLQJ ZLWK GLVSOD\ FRGH
3UREOHP Cause
• Drainage error, water is not fully drained
(
within 6 minutes
• Lock - error.
(
• Water level not reached after 8 minutes.
(
• Drain hose is self-syphoning..
• Water protective level - error..
(
22
6ROXWLRQ
• &OHDQ SXPS OWHU
• Check drain hose installation.
• Shut the door properly.
• Make sure that tap is fully opened and water
pressure is normal.
• Check drain hose installation.
• Contact the After sales
EN
service..