Small Cast Profile Surround; Models: Capcb, Capeb - Vermont Castings Montpelier Wood Insert MEAD3BS Installation Instructions Manual

Small Cast Profile Surround

Models: CAPCB, CAPEB

Read these instructions before beginning the instal-
lation.
CAUTION: Always place castings on a flat protected
work surface, such as a towel, blanket or carpet.
These instructions are for the assembly and installation
of the Small Cast Profile Surround to the Montpelier
Insert.
Carefully unpack and inspect all components from the
shipping box. Report any missing or damaged parts to
your dealer immediately. Install trim kit after all other
insert installation work has been completed, thoroughly
checked and tested for proper operation, leaks and
installation requirements.
Tools required: Tape measure.
Surround Parts
Column Right Assembly
Column, right
Boot, right
Slider clip, right
Bracket, On/Off switch (not used on Montpelier Insert)
1/4-20 Round head screw (2)
1/4-20 Wing screw (2)
1/4 Flat washer (3)
Column Left Assembly
Column, left
Boot, left
Slider clip, left
1/4-20 Round head screw
1/4-20 Wing screw (2)
1/4 Flat washer (3)
Key
Upper mounting bracket
Upper mounting bracket R
Hardware Bag
1/4-20 Wing Screw (5)
1/4 Flat washer (5)
4
(not used on Montpelier Insert)
Assembly Instructions
1. Place the key on your work surface with the thread-
ed holes facing up.
2. Place the column right assembly onto the key. (Fig.
4)
3. Place the column left assembly onto key. (Fig. 5)
Fig. 4 Place column right assembly onto key.
Fig. 5 Place column left assembly onto key.
KT425
4. Install the upper mounting bracket. Use the upper
column left
mounting without the marked "R" stamped on the
face. (Fig. 6)
assy
5. Fasten the upper mounting bracket to the key with
9/03
a 1/4-20 wing screw and 1/4 flat washer finger tight.
(Fig. 6)
Key
Column Right
Assembly
Key
KT424
column right
assy
Column Left
9/03
Assembly
30004451
KT424
KT425