WOHLHAUPTER VARIOBORE 536 Manual page 15

Fig. 1
Tool holders (Fig. 2)
Mounting
The tool holders
6
clamping surface using a threaded taper
pin in the slider.
5
Fig. 2
Serrated tool bodies and insert holders
(Fig. 3)
Mounting
The serrated tool bodies
in the slider using a threaded taper pin
To fasten the insert holders
they are mounted onto the K-profi le of the
serrated tool body and clamped using the
fi xing screw (tightening torque 8 Nm
9
(70.81 in. lbs.)). The insert holders can be
preset using the scale on the serrated tool
body and insert holders. The scale on the
insert holder is valid for a center slider
position (= 0).
5
Fig. 3
3
5 4
are fastened on a
5
6
are fastened
7
in place,
8
7 8
Serrated slide with coolant delivery
section, insert holder for boring (Fig. 4),
insert holder for outside turning (Fig. 5)
and counterweight
Mounting
To fasten the serrated slide
delivery section 11 is fastened using a
threaded taper pin
The serrated slide is aligned according to
the marking (
using the cap screws with washer. (tighte-
ning torque 4 Nm (35.40 in. lbs.)).
Insert holder
the coolant delivery section, roughly preset
according to the scale and then fastened
in place using cape screw
torque 8 Nm (70.81 in. lbs.)). The scale on
the insert holder is valid for a center slider
position (= 0).
The balancing counterweight
on the opposite side using a cap screw.
This counterweight must be fastened in
place to match the scale setting for the
mounted insert holder.
.
5
Fig. 4
9
the coolant
0
in the slider.
5
) and fastened in place
"
is mounted on the side with
„
(tightening
"
is fastened
¿
0
5
ß
English
„
"
"
¿
15